Videos

 

cold start.

Step 1.
Use tweezers to insert dablet so it lays flat on the nail
Step 2.
Apply carb cap immediately
Step 3.
Apply torch to nail for 10-15 seconds
Step 4.
Wait for the dablet to begin emitting vapor inside the chamber
Step 5.
Inhale and enjoy!
 
 

hot start.

Step 1.
Apply torch to nail for 20-30 seconds
For thick-walled nails: 45 seconds-1 minute
Step 2.
Wait 10-15 seconds for nail to cool
Step 3.
Use tweezers to insert dablet so it lays flat on the nail
Step 4.
Apply carb cap immediately
Step 5.
Wait for the dablet to begin emitting vapor inside the chamber
Step 6.
Inhale and enjoy!
 
 

portable devices.

Step 1.
Insert dablet so it lays flat inside the heating chamber
Step 2.
Re-assemble device and select desired heat setting
Step 3.
Press the activation button for roughly 20-30 seconds
Time may vary by device and preferred heat setting
Step 4.
Begin drawing as slow as possible while still holding button
Step 5.
Keep drawing slowly – slower draws keep the chamber warmer
Step 6.
Release the heat button when done drawing on device
Step 7.
Allow the dablet to cool before disposing